core4disc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| core4disc [2022/12/28 21:20] – [BOM] phatline | core4disc [2023/02/12 13:42] (current) – [Software] phatline | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| {{: | {{: | ||
| + | i think there is a error - PB2 is not connected to the CORE MODULE FIXME | ||
| ====== Building and BOM====== | ====== Building and BOM====== | ||
| parts off it is pick and place the other part is handsolder\\ | parts off it is pick and place the other part is handsolder\\ | ||
| Line 69: | Line 70: | ||
| **Order from Reichelt: | **Order from Reichelt: | ||
| - | 2x [[https:// | + | 2x [[https:// |
| - | 1x [[https:// | + | 1x [[https:// |
| - | 1x [[https:// | + | 1x [[https:// |
| - | 5x [[https:// | + | 5x [[https:// |
| - | 4x [[https:// | + | 4x [[https:// |
| {{: | {{: | ||
| + | |||
| + | |||
| + | ====== Software ====== | ||
| + | 1. If the Discoveryboard is a virgin-one then upload the bootloader [[http:// | ||
| + | 2. Upload the [[http:// | ||
| + | 3. Disconnect and Reconnect the USB-Cable to your PC, then type " | ||
| + | 4. Type following commands:\\ | ||
| + | < | ||
| + | set lcd_type 0x84 | ||
| + | set lcd_num_x 26 | ||
| + | set lcd_num_y 1 | ||
| + | set lcd_width 128 | ||
| + | set lcd_height 64 | ||
| + | store | ||
| + | </ | ||
| + | at least this has to be done when using this core for [[Triggermatrix5]]\\ | ||
| + | |||
| ====== To Do ====== | ====== To Do ====== | ||
| - | waiting for the assembled Prototype\\ | + | It works! next variant will be, without Discoveryboard and the STM32F407vgt6 directly soldered to the board...\\ |
| ====== Community users working on it ====== | ====== Community users working on it ====== | ||
core4disc.1672262403.txt.gz · Last modified: 2022/12/28 21:20 by phatline
