Differences

This shows you the differences between two versions of the page.

--- parts_faq [2016/06/15 12:42] – [What voltage capacitors should I buy?] psykhaze
+++ parts_faq [2016/06/15 12:47] (current) – [What is the correct polarity of the (resistor / capacitor / diode / etc)] psykhaze
@@ Line 1: / Line 1: @@
 ====== Parts FAQ (Frequently Asked Questions) ======
 \\
-\\
+{{ ::neonking:partsfaq.jpg?direct&400|}}
 ===== What wattage resistors should I buy? =====
@@ Line 16: / Line 17: @@
 **Resistors can be installed in any direction**.
-Smaller value capacitors (i.e. usually under 1 uF) generally have no polarity.  Anything above 1 uF is typically an electrolytic capacitor, and it will have a polarity marking.  Most often the "-" side is marked with a big stripe, although sometimes it's the "+" side that is marked.  (Strangely, the "+" side seems to be marked on capacitors made in U.S.A.)
+**Smaller value capacitors (i.e. usually under 1 uF) generally have no polarity**.  **Anything above 1 uF is typically an electrolytic capacitor, and it will have a polarity marking**.  Most often the "-" side is marked with a big stripe, although sometimes it's the "+" side that is marked.  (Strangely, the "+" side seems to be marked on capacitors made in U.S.A.)
 **//Diodes absolutely must be installed in the right direction//**.  Diodes have a stripe on the cathode side.
 Most other components have some sort of mark as to their correct orientation.  IC's will have a dot, transistors have a flat side, LEDs have a flat side (and the two leads will be different lengths).
+\\
+\\
 ===== What kind of switches do I need? =====
@@ Line 59: / Line 61: @@
 As you can see, there is no real standard for naming them, but the right switch by any other name will drive your DIN module ;)\\
 When in doubt, don't hesitate to contact the distributor for clarification. This may save you some headache and some money as some do not accept returns!
+\\
 \\
 ===== What size/type of faders should I buy? =====
@@ Line 65: / Line 68: @@
 Trying to save money on wobbly cheap plastic faders, uh? You might hate yourself for that decision after six months of using your favorite new midi-toy. Consider that.
+\\
+\\
 ===== What type of crystal do I need? =====
@@ Line 71: / Line 75: @@
 [[Crystals and Oscillators]]
+\\
+\\
 ===== I can't find a bridge rectifier to fit the PCB's. =====
 You can substitute four 1N4001 (or any of the 1N400X series) for the bridge rectifier, they will handle more than enough current.
+\\
+\\
 ===== What Power supply should I use, and how much power should it have? =====
@@ Line 99: / Line 105: @@
 Yes, 1N4004 is a replacement for 1N4002, it's just a type for higher Voltages (100V for 1N4002 vs. 400V for 1N4004). Any 1N400X diode will work in place of any other 1N400X diode -WITH A SMALLER NUMBER- Do replace a 1N4002 with a 1N4004 Don't replace a 1N4004 with a 1N4002
+\\
+\\
 ===== PIC Stuff =====