====== Building the GM5x5x5 ======
==== Introduction ====
The GM5x5x5 is a midi interface for your computer. bla bla bla
==== Building Level ====
Noob guides have an difficulty indication from 1 to 5 where 1 is easy and 5 is hard to build.
If you have never started a project before we urge you to start with a level 1 project first.

We indicate this project as Building level 3

===== Tools Needed =====
To start building your GM 5x5x5 board you will need some tools.
Offcourse you could be creative and use whatever you like but this document is trying to be failsafe.

  * Soldering Iron
  * Soldering Flux
  * Wire Cutter
  * Beer
  * etc put in pictures and so

===== Component List =====

The list is build up from components that should be solderd on the board in this order.
However exeptions can be made. See building chapter for changes.
==== Diodes ====
==== Resistors ====
==== Sockets ====
==== Capacitors ====
==== Other ====
====== Building ======
===== The Chip =====
| This is the most difficult part of the whole project. If you manage to pull it off the rest of the project will be a breeze. Go to Link for a vid tutoriol on how to solder this.... | {{:gm5x5x5:1.jpg|}} |
===== Diodes =====
|FIXME|{{:gm5x5x5:2.jpg|}}|
|FIXME|{{:gm5x5x5:3.jpg|}}|
===== Resistors =====
|FIXME|{{:gm5x5x5:4.jpg|}}|
|FIXME|{{:gm5x5x5:5.jpg|}}|
|I have accidently soldered a resistor in R9. There should't be a resistor in it yet|{{:gm5x5x5:6.jpg|}}|
|FIXME|{{:gm5x5x5:7.jpg|}}|
===== Crystal =====
|FIXME|{{:gm5x5x5:8.jpg|}}|
===== IC Sockets =====
|FIXME|{{:gm5x5x5:9.jpg|}}|
===== Capacitors =====
|FIXME|{{:gm5x5x5:a1.jpg|}}|
|FIXME|{{:gm5x5x5:a2.jpg|}}|
===== Pin Headers =====
|FIXME|{{:gm5x5x5:a3.jpg|}}|
===== Electrolytic Capacitor =====
|FIXME|{{:gm5x5x5:a4.jpg|}}|
|FIXME|{{:gm5x5x5:a5.jpg|}}|
===== USB Socket =====
|FIXME|{{:gm5x5x5:a6.jpg|}}|
===== DIN Sockets =====
|FIXME|{{:gm5x5x5:a7.jpg|}}|
===== Placing IC's =====
|FIXME|{{:gm5x5x5:a8.jpg|}}|