====== Line Transmit ======

A slightly more compact version of the MBHP Line Driver Transmitter.

===== Schematic =====

[[http://www.ucapps.de/mbhp/mbhp_line_driver_transmitter.pdf|MBHP Transmitter]]. 

The two obvious differences are the J3 jumper (disconnects +5V from being sent) and the addition of a 100mil header. This way a DB-25 (or something else?) with ribbon cable mounting could be positioned off-board and wired to the line driver with an IDC.

----


===== BOM v1.0 =====

**Please find the current BOM on [[http://midiphy.com]]. The table below is depreciated and will not be updated.**

^Type     ^Qty	^Value	   ^Package	^Parts^Mouser^Reichelt^Conrad^Other^Notes^
^Resistors^^^^^^^^^^	
|         |0 (2)   |100R 5%   |THT         |      |      |        |      |     |not really needed |
^Capacitors^^^^^^^^^^		
|         |2    |100nF |THT 2.5mm        |C1, C2      |      |        |      |     | |
^ICs^^^^^^^^^^		
|         |2    |MC3487 |DIP16 |IC1, IC2 | | | |  | |
^IC sockets^^^^^^^^^^		
|         |2    |  |DIP16      | | | |  | |
^Headers^^^^^^^^^^
|         |2    |1*2   |male                          |     |        |      |     | | |
|         |1 (0)    |1*3   |male                          |     |        |      |     | | |
|         |2    |2*5   |male                          |     |        |      |     | | |
|         |0 (1)    |2*13   |male                          |     |        |      |     | | |
^Sockets^^^^^^^^^^
|         |1 (0)    |DB-25 |female                          |      | |      |     | | |
^Hardware^^^^^^^^^^
|         |0 (3)    |M3 spacer     |                     | |        |      |     | |optional, suggest to panel mount |     



===== Versions =====

v1.0: first release.

===== Assembly =====

Building is straightforward, just decide on whether CONN1 is the typical DB-25 or a pin header.



----



==== License ====

Currently the design is (c) 2017 antilog devices with all rights reserved; all documentation is CC BY-NC-SA 3.0.