aout_4
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
aout_4 [2018/02/26 22:35] latigid_on [Headers and jumpers] |
aout_4 [2018/03/10 11:42] (current) latigid_on [Assembly] |
||
|---|---|---|---|
| Line 123: | Line 123: | ||
| ===== Assembly ===== | ===== Assembly ===== | ||
| - | The clearance with the common 3296 series trimpots is quite tight! Although everything does fit, you may wish to place the trimpots in before the surrounding resistors. The resistors could even go on the back of the board, as long as you don't melt the trimmer housings too much. There are smaller trimmers available, but | + | The clearance with the common 3296 series trimpots is quite tight! Although everything does fit, you may wish to place the trimpots in before the surrounding resistors. The resistors could even go on the back of the board, as long as you don't melt the trimmer housings too much. There are smaller trimmers available, but they seem to be quite pricey. |
| The 50k value for most resistors is not too important. 47k will work fine. | The 50k value for most resistors is not too important. 47k will work fine. | ||
aout_4.txt ยท Last modified: 2018/03/10 11:42 by latigid_on
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
