dout_module_digital_output
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
dout_module_digital_output [2008/11/23 16:29] this |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== General Informations ====== | ||
| - | |||
| - | A DOUT module is a digital output module, usually used to drive LEDs with a Midibox. | ||
| - | |||
| - | * [[http://www.ucapps.de/mbhp_dout.html|DOUT Module]] <sup>uCApps</sup>\\ | ||
| - | * [[DIN & DOUT Pintable]] | ||
| - | |||
| - | \\ | ||
| - | Note that hardware pin's will be counted D7 - D0 / O7 - O0 / QH - QA. In contrast, pins for DIN modules will be counted D0 - D7.\\ | ||
| - | Refer the DIN & DOUT Pintable to see the relation between software pin numbers and hardware pins. | ||
| - | \\ | ||
| - | ====== Connection to Core Module ====== | ||
| - | |||
| - | Check the version of your Boards; if you’re using SmashTV’s Core that’s equipped with double rows, you can build a split-cable to connect J8/J9 to a DIN and a DOUT: | ||
| - | |||
| - | {{http://www.audiocommander.de/picBrowser/galleries/070707_ACSensorizer/CORE_DIN_DOUT_J8J9_Cable.png}} | ||
| - | |||
dout_module_digital_output.1227457747.txt.gz · Last modified: 2008/11/23 16:29 by this
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
