User Tools

Site Tools


elo

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
elo [2018/03/10 11:02]
latigid_on [Dimensions]
elo [2018/03/10 11:29]
latigid_on [Interconnection to Core]
Line 339: Line 339:
 ===== Assembly ===== ===== Assembly =====
  
-Decide on the layoutOnly four encoders are supported. ENSW1 and ENSW4 are always available; EN2/ENSW2 and EN3/ENSW3 share pins. The switch for ENSW2/​ENSW3 ​is also sharedThis way one can choose whether ​to have switched encoders or encoders illuminated with WS2812B LEDs.+If using touch sensors, install ​the SMT parts firstCapacitor pads have rounded corners ​and there is a silkscreen line along the longer edge to help orient the partsSee above for how to connect TS parts (normally a wire link).
  
-If illuminated encoders are desiredinstall these and the associated capacitors first.+The WS2812 LEDs and associated caps should come nextfollowed by the SMT shift registers ​and resistor networks. See above for notes on the RNs.
  
-Next diodes and resistors/​linksAlign the diode band with the silkscreen legendNext the two electrolytic caps.+Here it is a good idea to test the LED functions before overlaying the encoders. 
 + 
 +The encoders can then be installed over the LEDs. They need to be raised above the LED (e.g. using a spacer piece of 2mm) so the shaft turns freely, and the mounting legs should be straightened for a secure connection. 
 + 
 +OLED displays should go in last. As they mount over the touch sensors, it would be smart to test the touch sensor operation before they are placed. 
 + 
 +Example usage: 
 + 
 +{{ :​elo:​elo_col1.zip |}}
  
-OLEDs could be socketed using a right-angle pin header. This means a corresponding female header would need to replace the standard 7-pin one common to these displays. 
  
-Headers, switches and encoders come last. Note the flat part of the switch, which must align with the DT6 switch body. Illuminated encoders should be raised up around 2mm to fit over the LED and still turn freely. 
  
  
Line 355: Line 361:
 ==== Interconnection to Core ==== ==== Interconnection to Core ====
  
-Headers are mentioned above. DIN/DOUT connect ​to DINX4/DOUTX4 ​or a DIOMATRIXJ10B to J10B+  * J1 to J4B (I2C) 
 +  * J3 to J89 (SRIO) 
 +  * J5/J6 to J15 or equivalent. The ribbon cable should have two IDCs on the ELO end, one for J5 and one for J6. 
 +  * J7 +5V as noted.
  
  
elo.txt · Last modified: 2018/03/10 11:29 by latigid_on