envelope-follower-bissel-based
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
envelope-follower-bissel-based [2021/01/05 22:59] phatline [To Do] |
envelope-follower-bissel-based [2021/01/05 23:00] phatline |
||
|---|---|---|---|
| Line 88: | Line 88: | ||
| Debugging First Version\\ | Debugging First Version\\ | ||
| **experiment with the Smooting CAP:** a Header is connected paralell to a integrated 100nF Cap, connect there a CAP to encrease the smoothing\\ | **experiment with the Smooting CAP:** a Header is connected paralell to a integrated 100nF Cap, connect there a CAP to encrease the smoothing\\ | ||
| - | experiment with the Frequency Pot which is a lin10K + 1K Serial Resistor which gives a range of 1K-12K - i also made a Header here, which you can bridge then you have 1-12K, or you put a resistor there for example a 5K, then you will get a range from 6-16K... \\ | + | **experiment with the Frequency Pot:** a lin10K + 1K internal Serial Resistor which gives a range of 1K-12K - i also made a Header here, which you can bridge then you have 1-12K, or you put a resistor there for example a 5K, then you will get a range from 6-16K... \\ |
| I addet some Jumpers to break the circuit for debugging or measurement\\ | I addet some Jumpers to break the circuit for debugging or measurement\\ | ||
| \\ | \\ | ||
envelope-follower-bissel-based.txt ยท Last modified: 2021/01/22 02:06 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
