home:skills:troubleshooting:firmware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
home:skills:troubleshooting:firmware [2009/07/05 21:13] 87.194.188.147 |
home:skills:troubleshooting:firmware [2009/07/05 21:16] 87.194.188.147 |
||
|---|---|---|---|
| Line 40: | Line 40: | ||
| The pins are identified on the MB SID schematic: [[http://www.ucapps.de/mbhp/mbhp_sid_v3.pdf]] | The pins are identified on the MB SID schematic: [[http://www.ucapps.de/mbhp/mbhp_sid_v3.pdf]] | ||
| + | |||
| i.e. | i.e. | ||
| - | CS# is pin 8 (anti-clockwise from the top left) | + | |
| - | A0 is pin 9 | + | * RES# is pin 5 (anti-clockwise from the top left) |
| - | A4 is pin 13 | + | * CS# is pin 8 |
| - | D0 is pin 15 | + | * A0 is pin 9 |
| - | D7 is pin 22 | + | * A4 is pin 13 |
| + | * D0 is pin 15 | ||
| + | * D7 is pin 22 | ||
| To measure the voltage (and test the connection to that pin is good), connect your multimeter's red lead to ___?___ and the black lead to ___?___ and select the pin using the modulation wheel. | To measure the voltage (and test the connection to that pin is good), connect your multimeter's red lead to ___?___ and the black lead to ___?___ and select the pin using the modulation wheel. | ||
home/skills/troubleshooting/firmware.txt · Last modified: 2009/07/06 18:31 by 87.194.188.147
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
