This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
m16 [2018/09/08 13:16] antichambre [Dimension] |
m16 [2018/09/08 14:10] antichambre [Special command messages] |
||
---|---|---|---|
Line 145: | Line 145: | ||
The **m16** can receive some specifics commands and send back some status messages.\\ | The **m16** can receive some specifics commands and send back some status messages.\\ | ||
when **CIN=0x1**(local command), the **m16** will parse the message as a command and apply the requested change.\\ | when **CIN=0x1**(local command), the **m16** will parse the message as a command and apply the requested change.\\ | ||
- | * Port(Cable)value becomes Group Command Code.\\ | + | * Port(Cable)value becomes Group Command Code(GCC).\\ |
- | * evnt0 is the command number.\\ | + | * evnt0 is the command number(CMD.\\ |
* evnt1 and evnt2 are the value bytes.\\ | * evnt1 and evnt2 are the value bytes.\\ | ||
List of the commands:\\ | List of the commands:\\ | ||
Line 154: | Line 154: | ||
</WRAP>\\ | </WRAP>\\ | ||
</WRAP>\\ | </WRAP>\\ | ||
+ | With System commands, you will be able to | ||
+ | * Put SPI or UARTs in loopback for testing purpose. | ||
+ | * Enable MIDI activity status messages over SPI(MISO). | ||
+ | |||
+ | There's only one MIDI configuration command, for Running Status enabler.\\ | ||
+ | |||
+ | With GPIOx commands, you can configure and set the GPIO ports.\\ | ||
\\ | \\ |