mididoc:midibox_cv_v2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
mididoc:midibox_cv_v2 [2016/06/26 20:51] psykhaze |
mididoc:midibox_cv_v2 [2016/06/27 11:15] psykhaze [MBHP Modules Required] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Introduction ===== | ===== Introduction ===== | ||
| - | MIDIbox CV V2 is the successor of MIDIbox CV V1 with focus on digital, high-resolution modulation of CV outputs and an enhanced control surface. | + | MIDIbox CV V2 is the successor of [[:midibox_cv_v1|MB-CV]] V1 with focus on digital, high-resolution modulation of CV outputs and an enhanced control surface. |
| [[http://www.ucapps.de/midibox_cv_v2.html|Official Ucapps Page]] | [[http://www.ucapps.de/midibox_cv_v2.html|Official Ucapps Page]] | ||
| Line 25: | Line 25: | ||
| ===== Control Voltages Features ===== | ===== Control Voltages Features ===== | ||
| - | * Typically 12bit outputs with common MBHP based [[AOUT Module]]. Internally working with 16bit | + | * Typically 12bit outputs with common MBHP based [[:AOUT Module]]. Internally working with 16bit |
| * Volt/Octave (positive and negative) and Herz/Volt characteristic | * Volt/Octave (positive and negative) and Herz/Volt characteristic | ||
| * Configurable slew rate to "smooth" the output curve (e.g. if controlled only by 7bit CCs) | * Configurable slew rate to "smooth" the output curve (e.g. if controlled only by 7bit CCs) | ||
| Line 55: | Line 55: | ||
| * [[:Din Module]] | * [[:Din Module]] | ||
| * [[:Dout Module]] | * [[:Dout Module]] | ||
| - | * [[:SCS Module]] | + | * [[:SCS Module]] // Optional// |
| \\ | \\ | ||
| Line 69: | Line 69: | ||
| ==== Led Rings Encoders ==== | ==== Led Rings Encoders ==== | ||
| + | |||
| + | {{ :mididoc:neonking:midibox_cv2_lre8x2.jpg?direct&500 |}} | ||
| Up to 32 free assignable rotary encoder functions with support for LED rings are available. The encoders have to be connected to a MBHP_DIN module, the LED rings to four shift registers of a MBHP_DOUT module. | Up to 32 free assignable rotary encoder functions with support for LED rings are available. The encoders have to be connected to a MBHP_DIN module, the LED rings to four shift registers of a MBHP_DOUT module. | ||
| - | **[[:mb-lre8x2cs_pcb|LRE8x2]] ** | + | **[[:mb-lre8x2cs_pcb|LRE8x2 Page]] ** |
mididoc/midibox_cv_v2.txt ยท Last modified: 2016/06/27 11:15 by psykhaze
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
