This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
mididocs:seq:blm16x16_build_guide [2016/03/31 11:42] latigid_on [Parts notes] |
mididocs:seq:blm16x16_build_guide [2016/08/10 20:39] latigid_on [Tools needed] |
||
---|---|---|---|
Line 123: | Line 123: | ||
* Soldering iron, I managed with a normal tip but it’s a bit tricky with some components | * Soldering iron, I managed with a normal tip but it’s a bit tricky with some components | ||
- | * Solder, probably leaded. 0.5mm will make the finer pitch stuff easier but again I managed with 1mm | + | * Solder, probably leaded. 0.5mm is strongly recommended for at least the ICs (1206 can be easily done with 1mm solder). |
* Desoldering wick and/or solder pump. Useful when the pads get too much solder | * Desoldering wick and/or solder pump. Useful when the pads get too much solder | ||
* Tweezers to pick and place components | * Tweezers to pick and place components |