This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
mididocs:seq:blm16x16_build_guide [2016/03/31 11:42] latigid_on [Parts notes] |
mididocs:seq:blm16x16_build_guide [2017/11/24 19:52] latigid_on [Dimensions] |
||
---|---|---|---|
Line 123: | Line 123: | ||
* Soldering iron, I managed with a normal tip but it’s a bit tricky with some components | * Soldering iron, I managed with a normal tip but it’s a bit tricky with some components | ||
- | * Solder, probably leaded. 0.5mm will make the finer pitch stuff easier but again I managed with 1mm | + | * Solder, probably leaded. 0.5mm is strongly recommended for at least the ICs (1206 can be easily done with 1mm solder). |
* Desoldering wick and/or solder pump. Useful when the pads get too much solder | * Desoldering wick and/or solder pump. Useful when the pads get too much solder | ||
* Tweezers to pick and place components | * Tweezers to pick and place components | ||
Line 131: | Line 131: | ||
* Flat work surface | * Flat work surface | ||
* Multimeter, test continuity between pads | * Multimeter, test continuity between pads | ||
+ | |||
+ | ==== Dimensions ==== | ||
+ | |||
+ | Here are the dimensions for the button, hole and slider locations. Note that the unmarked mounting holes are M3 (3.2mm diameter) | ||
+ | |||
+ | {{:blm16x16_x:dimensions.png?300|}} | ||
+ | {{:blm16x16_x:dimensions.png?linkonly|}} | ||
+ | |||
+ | |||
+ |