mididocs:seq:blm16x16_build_guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
mididocs:seq:blm16x16_build_guide [2016/08/10 20:39] latigid_on [Tools needed] |
mididocs:seq:blm16x16_build_guide [2017/11/24 19:50] latigid_on [Tools needed] |
||
|---|---|---|---|
| Line 131: | Line 131: | ||
| * Flat work surface | * Flat work surface | ||
| * Multimeter, test continuity between pads | * Multimeter, test continuity between pads | ||
| + | |||
| + | ==== Dimensions ==== | ||
| + | |||
| + | Here are the dimensions for the button, hole and slider locations. Note that the unmarked mounting holes are M3 (3.2mm diameter) | ||
| + | |||
| + | {{::blm16x16_x:dimensions.png?direct&300|}} | ||
| + | |||
| + | |||
| + | |||
mididocs/seq/blm16x16_build_guide.txt ยท Last modified: 2017/11/24 19:52 by latigid_on
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
