opl3_module_modified
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
opl3_module_modified [2014/01/28 11:05] eptheca |
opl3_module_modified [2014/01/28 11:40] (current) eptheca |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| - Bridge C20 pads (to supply Ground for the op-amps)\\ | - Bridge C20 pads (to supply Ground for the op-amps)\\ | ||
| - Leave out bridges to IC6\\ | - Leave out bridges to IC6\\ | ||
| - | - Use MCP6004 for IC3 and IC5\\ | + | - Use MCP6004 for IC3 and IC5 (IC3 The op-amp, not the DAC, labeling error)\\ |
| - Supply 5V to the +12V pin, and Ground to Ground\\ | - Supply 5V to the +12V pin, and Ground to Ground\\ | ||
opl3_module_modified.1390907158.txt.gz ยท Last modified: 2014/01/28 11:05 by eptheca
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
