sd_card_module
This is an old revision of the document!
A PCRE internal error occured. This might be caused by a faulty plugin
====== SD Card Module ====== {{ ::neonking:mbhp_sdcard_lowcost_10.jpg?direct&400 |}} ===== Interconnection ===== {{ ::neonking:mbhp_sdcard.jpg?direct&400 |}} ===== STM32 Specific ===== The resistor array R30 of the MBHP_CORE_STM32 module shouldn't be connected when a SD Card is used, because pads are configured in Push-Pull mode at 3.3V. SD Card transfers could work unstable with these Pull-Up resistors!
sd_card_module.1467025192.txt.gz · Last modified: 2016/06/27 10:59 by psykhaze
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
