seqv4plus_enc-plate
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
seqv4plus_enc-plate [2017/09/12 20:06] latigid_on [Assembly] |
seqv4plus_enc-plate [2018/12/18 09:35] (current) latigid_on [BOM v1.0] |
||
|---|---|---|---|
| Line 33: | Line 33: | ||
| ===== BOM v1.0 ===== | ===== BOM v1.0 ===== | ||
| + | **Please find the current BOM on [[http://midiphy.com]]. The table below is depreciated and will not be updated.** | ||
| ^Type ^Qty ^Value ^Package ^Parts^Mouser^Reichelt^Conrad^Other^Notes^ | ^Type ^Qty ^Value ^Package ^Parts^Mouser^Reichelt^Conrad^Other^Notes^ | ||
| Line 40: | Line 41: | ||
| | |8 |STEC12| | | |STEC12E08 | | | | | | |8 |STEC12| | | |STEC12E08 | | | | | ||
| ^Headers^^^^^^^^^^ | ^Headers^^^^^^^^^^ | ||
| - | | |3 |1*10 |through-board |MDF7-10S-2.54DSA(55) | | | | | | | + | | |3 |1*10 |through-board | |MDF7-10S-2.54DSA(55) | | | | | |
| ^Hardware^^^^^^^^^^ | ^Hardware^^^^^^^^^^ | ||
| | |2 |M2 washer |3mm? | | | | | | | | | |2 |M2 washer |3mm? | | | | | | | | ||
| Line 55: | Line 56: | ||
| Start with the eight encoders and diodes. Important to note: | Start with the eight encoders and diodes. Important to note: | ||
| - | * There is <3mm vertical distance between the stacked PCB sets. If diode or encoder legs are too long, they may short out the components below. I need to check the assembly. It might be that all parts on the ENC-PLATE PCB are soldered from the top and the legs protruding through are trimmed flush on the underside. | + | * There is less than 3mm vertical distance between the stacked PCB sets. If diode or encoder legs are too long, they may short out the components below. I need to check the assembly. It might be that all parts on the ENC-PLATE PCB are soldered from the top and the legs protruding through are trimmed flush on the underside. |
| Once the diodes and encoders are okay, line up the headers, using a [[seqv4plus_le_mec|le MEC]] board and optionally some of the mounting points. Once you are happy, solder the three 1*10 male pin headers on the lower PCB, and only then fix the through-board female headers on the upper PCB. | Once the diodes and encoders are okay, line up the headers, using a [[seqv4plus_le_mec|le MEC]] board and optionally some of the mounting points. Once you are happy, solder the three 1*10 male pin headers on the lower PCB, and only then fix the through-board female headers on the upper PCB. | ||
seqv4plus_enc-plate.1505246808.txt.gz ยท Last modified: 2017/09/12 20:06 by latigid_on
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
