troubleshooting_lcd_displays
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
troubleshooting_lcd_displays [2006/10/15 09:35] 127.0.0.1 (old revision restored) |
troubleshooting_lcd_displays [2007/09/19 09:40] nebula |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| //SmashTV// | //SmashTV// | ||
| - | If you have connected A and K right and your backlight is still flashing AND your regulator is very hot....then you can be sure that your power supply isn't strong enough for the whole box (especially if you have more than one display). Solution: Build a seperate power supply for the backlight(s). | + | If you have connected A and K right and your backlight is still flashing AND your regulator is very hot....then you can be sure that your power supply isn't strong enough for the whole box (especially if you have more than one display). Solution: Build a separate power supply for the backlight(s). |
| //Doc// | //Doc// | ||
| Line 41: | Line 41: | ||
| ===== 'Fixed BOR setup' message on LCD ===== | ===== 'Fixed BOR setup' message on LCD ===== | ||
| BOR stands for Brown Out Reset, and this message indicates power problems. For a full desription, please see the [[fixed BOR setup]] page. | BOR stands for Brown Out Reset, and this message indicates power problems. For a full desription, please see the [[fixed BOR setup]] page. | ||
| - | |||
troubleshooting_lcd_displays.txt ยท Last modified: 2008/07/20 12:43 by stryd_one
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
