User Tools

Site Tools


wcore_midi8

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
wcore_midi8 [2017/09/10 11:23]
latigid_on created
wcore_midi8 [2018/12/18 09:38] (current)
latigid_on [BOM v1.0]
Line 30: Line 30:
  
 ===== BOM v1.0 ===== ===== BOM v1.0 =====
 +
 +**Please find the current BOM on [[http://​midiphy.com]]. The table below is depreciated and will not be updated.**
  
 ^Type     ​^Qty ^Value  ​  ​^Package ^Parts^Mouser^Reichelt^Conrad^Other^Notes^ ^Type     ​^Qty ^Value  ​  ​^Package ^Parts^Mouser^Reichelt^Conrad^Other^Notes^
Line 60: Line 62:
  
 Building is straightforward with all part values indicated. Start with the flattest components (resistors and diodes, IC sockets) and work up to the higher ones. Ensure the DIN sockets are snug against the PCB before soldering all of the pins! Building is straightforward with all part values indicated. Start with the flattest components (resistors and diodes, IC sockets) and work up to the higher ones. Ensure the DIN sockets are snug against the PCB before soldering all of the pins!
 +
 +If a BLM connector is used, consider how it will be powered (see above). Don't close the jumper below J3 unless you're using the USB +5V to power it. E.g. if you had connected a higher voltage to pin 8 on I4 and closed the jumper, then the USB power would fight with the external one and let out the magic smoke.
  
  
wcore_midi8.1505042584.txt.gz ยท Last modified: 2017/09/10 11:23 by latigid_on