This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
wcoref4_pcb [2018/08/20 21:27] latigid_on [Versions] |
wcoref4_pcb [2018/08/20 21:29] latigid_on |
||
---|---|---|---|
Line 32: | Line 32: | ||
^Resistors^^^^^^^^^^ | ^Resistors^^^^^^^^^^ | ||
| |1 |330R 5% |THT |R102 | | | | | | | | |1 |330R 5% |THT |R102 | | | | | | | ||
- | | |4 |1k 5% |1206 |R7B1-4 | | | | | | | + | | |1 |560R 5% |THT |R33D | | | | | | |
+ | | |3 |1k 5% |1206 |R33A,B,C | | | | | | | ||
| |2 |1k 5% |THT |R11, R13 | | | | | | | | |2 |1k 5% |THT |R11, R13 | | | | | | | ||
| |2 |2k2 5% |THT |R7A, R8A | | | | | | | | |2 |2k2 5% |THT |R7A, R8A | | | | | | | ||
Line 68: | Line 69: | ||
* The [[wcore_usb|USB]] board is now combined with the wCore. It can be used as is or broken apart and the USB reconnected with wires, a 2.54mm header or a 10-pin Micro-MaTch connector. | * The [[wcore_usb|USB]] board is now combined with the wCore. It can be used as is or broken apart and the USB reconnected with wires, a 2.54mm header or a 10-pin Micro-MaTch connector. | ||
* Resistors R7B1-4 were renamed properly to R33A-D. R33**D** should have a different value (560~820R) than R33A/B/C (1k). Using longer cables on J15A/B and a smaller resistance for R33D could lead to displays not initialising properly. | * Resistors R7B1-4 were renamed properly to R33A-D. R33**D** should have a different value (560~820R) than R33A/B/C (1k). Using longer cables on J15A/B and a smaller resistance for R33D could lead to displays not initialising properly. | ||
+ | * There is a circular silkscreen mark that aligns with the same mark on the Waveshare breakout. | ||