wilba_mb_6582_control_surface_construction_guide
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
wilba_mb_6582_control_surface_construction_guide [2009/10/17 14:31] – Kyo | wilba_mb_6582_control_surface_construction_guide [2014/05/23 17:31] – link fix smashtv | ||
---|---|---|---|
Line 153: | Line 153: | ||
Continuity check the ribbon cable. Make sure there are NO SHORTS between any two adjacent pins of the ribbon cable joints. Make sure GND and 5V are not connected (the single 2-wire cable). | Continuity check the ribbon cable. Make sure there are NO SHORTS between any two adjacent pins of the ribbon cable joints. Make sure GND and 5V are not connected (the single 2-wire cable). | ||
- | ***Note** Bugfight created a detachable solution by using Right Angled SIL Headers on the base PCB in [[http:// | + | ***Note** Bugfight created a detachable solution by using Right Angled SIL Headers on the base PCB in <del>[[http:// |
- | + | ||
- | Click [[http://www.midibox.org/ | + | |
+ | Click < | ||
+ | More interconnect info: [[http:// | ||
**woohoo!** nearly finished! | **woohoo!** nearly finished! | ||
Line 165: | Line 165: | ||
- | ***Note*** Please see Wilbas post [[http:// | + | ***Note*** Please see Wilbas post <del>[[http:// |
Here is a guide to soldering the wires to the LCD. I suggest " | Here is a guide to soldering the wires to the LCD. I suggest " |
wilba_mb_6582_control_surface_construction_guide.txt · Last modified: 2020/12/15 15:13 by m00dawg