wilba_mb_seq_construction_guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
wilba_mb_seq_construction_guide [2013/09/20 21:13] smashtv |
wilba_mb_seq_construction_guide [2018/04/01 21:06] phatline |
||
|---|---|---|---|
| Line 147: | Line 147: | ||
| |J4 | Datawheel Encoder| to PCB using Wires | | |J4 | Datawheel Encoder| to PCB using Wires | | ||
| |J5 | Datawheel Switch | (optional) for encoder with switch | | |J5 | Datawheel Switch | (optional) for encoder with switch | | ||
| + | |||
| + | |||
| + | ====== Trouble Shoot ====== | ||
| + | |||
| + | to figure out that your problems with that pcb are softwareside (buggy firmware, or fals hw-config), you can test all Buttons and LEDs with that firmware:\\ | ||
| + | {{:phatline:SEQ-CS-TEST.zip|the Code}} | ||
wilba_mb_seq_construction_guide.txt ยท Last modified: 2018/04/01 21:06 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
