xyz-ir-controller
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
xyz-ir-controller [2020/02/09 02:30] phatline |
xyz-ir-controller [2020/02/09 05:14] phatline |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| ==== MB MODs ==== | ==== MB MODs ==== | ||
| - | How to get it working without touching a SERIAL PROTOCOL? dont using the onboard DACS, instead use the MB-Core STM32F4 J5A AIN-Port....\\ | + | How to get it working without touching a SERIAL PROTOCOL?\\ |
| + | dont using the onboard DACS, instead use the MB-Core STM32F4 J5A AIN-Port....\\ | ||
| {{:phatline:xyz-pcb-mod.JPG?800|}}\\ | {{:phatline:xyz-pcb-mod.JPG?800|}}\\ | ||
| + | Negative: using a lot of bandwith.\\ | ||
| + | |||
| + | I connected all 4 IR-Transistor-Circuit directly to J5A\\ | ||
| + | The IR-Diode I connected to Pin1 of J10A. | ||
xyz-ir-controller.txt · Last modified: 2020/02/09 05:14 by phatline
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
