User Tools

Site Tools


xyz-ir-controller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
xyz-ir-controller [2020/02/07 00:18]
phatline created
xyz-ir-controller [2020/02/09 05:14] (current)
phatline
Line 3: Line 3:
 or how to DIY\\ or how to DIY\\
  
-{{:​phatline:​xyz-ausfuehrung.JPG?​600|}}\\+{{:​phatline:​xyz-ausfuehrung.JPG?​800|}}\\
  
 ===== Introduction ===== ===== Introduction =====
Line 13: Line 13:
 ==== PCB/​Shematic ==== ==== PCB/​Shematic ====
 first a took a shot of the Front&​Back of the IR-PCB... then i matched it, and redrawed every path...\\ ​ first a took a shot of the Front&​Back of the IR-PCB... then i matched it, and redrawed every path...\\ ​
-{{:​phatline:​xyz-pcb-all.JPG?​600|}}\\+{{:​phatline:​xyz-pcb-all.JPG?​800|}}\\
  
 i removed the orginal picture:\\ i removed the orginal picture:\\
-{{:​phatline:​xyz-pcb.jpg.JPG?600|}}\\+{{:​phatline:​xyz-pcb.JPG?​800|}}\\ 
 + 
 +==== MB MODs ==== 
 +How to get it working without touching a SERIAL PROTOCOL?​\\ 
 +dont using the onboard DACS, instead use the MB-Core STM32F4 J5A AIN-Port....\\  
 +{{:​phatline:​xyz-pcb-mod.JPG?800|}}\\ 
 +Negative: using a lot of bandwith.\\ 
 + 
 +I connected all 4 IR-Transistor-Circuit directly to J5A\\ 
 +The IR-Diode I connected to Pin1 of J10A.
  
  
xyz-ir-controller.1581034690.txt.gz · Last modified: 2020/02/07 00:18 by phatline