no way to compare when less than two revisions

Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+====== SCS OLED module ======
+Combination of 0.96" SSD1306 OLEDs and switches for an [[http://www.ucapps.de/midibox_ng_manual_scs.html|SCS]]
+===== Schematic =====
+Refer to the SCS schematic or below for J1/button and encoder pinning and the Core module (J15) for J5/OLEDs.
+----
+===== BOM v1.0 =====
+^	Type	^	Part	^	Value	^
+|Caps   	|	C25	|	DNF	|
+|		|	C26	|	DNF	|
+|		|	C29	|	10uF polarised	|
+|Encoder	|	EN1	|	12mm	|
+|		|	EN2	|	12mm	|
+|Header  	|	J1	|	PINHD-2X54WALL	|
+|		|	J2	|	+5V	|
+|		|	J5	|	PINHD-2X54WALL	|
+|OLEDs          |	LCD1	|	0.96_OLED	|
+|		|	LCD2	|	0.96_OLED	|
+|		|	LCD3	|	0.96_OLED	|
+|		|	LCD4	|	0.96_OLED	|
+|Resistors	|	R3	|	DNF	|
+|		|	R4	|	DNF	|
+|		|	R7	|	DNF	|
+|		|	R9	|	2k2	|
+|Switches	|	S1(A)	|	DT6 or 6mm	|
+|		|	S2(A)	|	DT6 or 6mm	|
+|		|	S3(A)	|	DT6 or 6mm	|
+|		|	S4(A)	|	DT6 or 6mm	|
+|		|	S5(A)	|	DT6 or 6mm	|
+|		|	S6(A)	|	DT6 or 6mm	|
+===== Versions =====
+v1.0: first release
+===== Assembly =====
+Decide on the configuration to be used. Any combination of switches, encoders or OLEDs is possible if they fit.
+Only one encoder is wired to the J1 header. If you want to use the EN2 position, wire the legs to the empty EN1 solder points.
+R9 and C29 form the power-on reset for OLEDs. R7 should not be installed. R3/C25/R4/C26 form a termination shunt for OLED data lines. They shouldn't be required.
+The switches accommodate either DT6 or 6mm switches (obviously only one type!). For DT6 switches, ensure the flat side is aligned with the PCB silkscreen.
+J2 can supply power if needed.
+==== Interconnections ====
+{{::scsoled:j1.png?nolink&200|}}
+J1 is the SCS header, connecting to J10A
+J2 can provide power as indicated; it is also connected on J5.
+J5 connects to J15 on the Core (or equivalent)
+===== Dimensions =====
+{{:scsoled:scsoled.png?link&600|}}
+{{ :scsoled:doku.zip |}}
+===== License =====
+Currently the design is (c) 2016 antilog devices with all rights reserved; all documentation is CC BY-NC-SA 3.0.